Beskrivelse
Professional bodyshops know and trust Power-TEC products and this new parking distance sensor hole cutter set (part number 92489) lets you cut dimensionally accurate holes cleanly and quickly when refitting the parking sensors after accident damage.
The operation couldn’t be easier; drill the pilot hole in the new panel (5/16″ HSS drill bit included), then choose the correct combination of die and cutter punch from the set (ten hole sizes available). Assemble with the die behind the panel and the cutter punch on the outer face then tighten the nut on the force screw with a 12mm socket and within seconds the hole is cut, leaving a clean finished edge on the outer surface of the panel.
Up to 5 mm plastic can be cut and the following hole sizes are accommodated in the set: 32, 26.7, 26, 24, 22.5, 20, 19, 18.2, 18, and 17mm.
Part of the Power-TEC range of parking sensor kits which includes 92468 (18.2mm cutter plus clamps to keep the sensor brackets in place while the mounting adhesive sets) and 92471 which includes 18.2, 18.4 and 26mm cutters plus three sizes of clamp.
Professional results every time whenever you need to cut holes for parking distance sensors; the set is available now from your Power-TEC supplier.
LAS92489_Instructions_V2
LAS92489_PIS
